ABB Feather Duster V2, Руководство по эксплуатации продукта

Страница: 18 / 192

1.3 Safety risks
1.3.1 Safety risks during installation and service work
Requirements on personnel
Only persons who know the Product and are trained in the operation and handling
of the Product are allowed to maintain the Product. Persons who are under the
influence of alcohol, drugs or any other intoxicating substances are not allowed
to install, maintain, repair, or use the Product.
• Those in charge of operations must make sure that safety instructions are
available for the installation in question.
• Those who install or service/maintain the Product must have the appropriate
training for the equipment in question and in any safety matters associated
with it.
• Personnel should be trained on responding to emergency or abnormal
situations.
General risks during installation and service
The instructions in the product manual must always be followed.
• Never turn the power on to the Product before it is properly fixed and bolted
to its foundation/support.
• Make sure that no one else can turn on the power to the controller and
Product while you are working with the system. A good method is to always
lock the main switch on the controller cabinet with a safety lock.
• Make sure that no one else can turn on the power to the controller and
Product while you are working with the system. A good method is to remove
the power cable to the controller.
• If the Product is installed at a height, hanging, or other than standing directly
on the floor, there may be additional risks than those for a Product standing
directly on the floor.
• Energy stored in the Product for the purpose of counterbalancing certain
axes may be released if the Product, or parts thereof, are dismantled.
• Never use the Product as a ladder, which means, do not climb on the
controller, motors, or other parts during service work. There is a risk of
slipping because of the high temperature of the motors and oil spills that can
occur on the Product. There is also a risk of the Product being damaged.
• To avoid damaging the Product, make sure that there are no loose screws,
turnings, or other parts inside the Product after work has been performed.
Safety risks during operational disturbances
Corrective maintenance must only be carried out by qualified personnel who are
familiar with the entire installation as well as the special risks associated with its
different parts.
Continues on next page
18 Product manual - Feather Duster V2
3HAX010000210 Revision: A
© Copyright 2018 ABB. All rights reserved.
1 Safety
1.3.1 Safety risks during installation and service work