Authorization
Operating instructions V 1.00 Document: V 1.00 / Document No.: 105728
│
Date 28.05.2018
│
17
5.2.3
Teaching in the slave card
The RFID slave card can be used to authorize a charging procedure. The RFID master card is
required to teach in an RFID slave card.
No charging session may be active for the teaching in and no vehicle may be connected to the
charging station. The LED bar must flash blue.
To teach in the RFID slave card, proceed as follows:
1. Hold the RFID master card in front of the RFID reader until a signal tone sounds.
2. Within 3 seconds hold the new RFID slave card to be taught in front of the RFID reader. A
successful programming process is confirmed by a rising tone sequence.
3. Confirm the teach-in process within 3 seconds by holding the RFID mas- ter card in front of
the RFID reader again. The procedure is concluded by a further rising tone sequence.
The LED bar then flashes blue to indicate that authorization to start a charge is required.
5.2.4
Deleting RFID cards
In some cases, it is necessary to delete the taught-in RFID cards. For exam- ple, after loss of an
RFID card or in oder to charge without authorization. It is only possible to delete all taught-in
RFID cards; deleting a single RFID card is not possible.
To do this, proceed as follows:
1. Remove the housing cover and connection panel cover to access the service button (see
5.2.1 Preparing the charging station).
2. Hold the service button [1] pressed in
the connection panel until the sec-
ond signal tone sounds (approx. 10
seconds).
–
The charging station will now
automatically perform a restart,
deleting all previously taught-in
cards in the process.
If the deletion was successful, the LED bar flashes green and charging with- out authorization is
possible.
5.2.5
RFID authorization at charging network
If the charging station: is part of a charging network (EVLunic Pro S as slave charging station: in
a master / slave network), then all RFID cards must be taught in on the master charging station
(EVLunic Pro M). The administration of the permitted RFID cards for the entire charging network
is carried out at the master charging station. Information on this can be found in the specific
"Configuration Manual".
Содержание EVLunic
Страница 2: ......
