ABB AO2000-LS25, Руководство пользователя

Страница: 41 / 88

AO2000-LS25
LASER ANALYZERS | OI/AO2000-LS25-EN REV. D 41
Power supply / analog inputs
Table 24 shows the connection assignment of the power supply
connectors and the analog inputs (4 to 20 mA). This connection
assignment applies only to the connector on the cable for the
transmitter unit and only to devices
without explosion
protection.
Terminal Color Signal
1 Blue* Temperature sensor −
2 Red* Temperature
3 Black* Pressure sensor −
4 Violet* Pressure
5 White/Green* Flow sensor −
6 Brown/Green* Flow
7 Gray/Pink* S24V
8 Blue/Red* Sensors AGND
9 White/Yellow* S24V
10 White PWR+ (+18 to 36 V)
11 Green PWR+ (+18 to 36 V)
12 Gray PWR+ (+18 to 36 V)
13 Brown PWR − (0V)
14 Yellow PWR − (0V)
15 Pink PWR − (0V)
Table 24: Power cable connections (Phoenix connectors)
(*) Cables may be replaced at the transmitter end of the cable (see Connecting
analog inputs (option) on page 45).
Note
• All 3 power pairs (PWR+/PWR−) should be wired to ensure
even current flow through the connector.
• External temperature and pressure sensors are connected to
the connector of the transmitter end of the cable, see
Connecting analog inputs (option) on page 45.
Service interface (RS232)
Terminal Signal Comments
1 Data Carrier Detect Connected to terminal 4
2 Transmit Data —
3 Receive Data —
4 Data Terminal Ready —
5 Ground —
6 Data Set Ready Connected to terminal 4
7 Request To Send Connected to terminal 8
8 Clear To send Connected to terminal 7
9 Ring Indicator Not assigned
Table 25: Service interface connection assignment
Network interface (Ethernet)
Terminal Signal
1 TX+
2 TX-
3 RX+
4 — Not assigned
5 — Not assigned
6 RX-
7 — Not assigned
8 — Not assigned
Table 26: Connection assignment of the network interface RJ-45