ABB ACSM1 Series, Руководство по прошивке

Страница: 150 / 334

Parameters and firmware blocks
150
(3) LAST SPEED Protection is active. The drive generates alarm FIELDBUS COMM
and freezes the speed to the level the drive was operating at. The
speed is determined by the average speed over the previous 10
seconds.
WARNING ! Make sure that it is safe to continue operation in
case of a communication break.
50.03 COMM LOSS T OUT FW block: FIELDBUS (see above)
Defines the time delay before the action defined by parameter 50.02 COMM LOSS FUNC is taken.
Time count starts when the link fails to update the message.
0.3…6553.5 s Delay for fieldbus communication loss function.
50.04 FBA REF1 MODESEL FW block: FIELDBUS (see above)
Selects the fieldbus reference FBA REF1 scaling and the actual value, which is sent to the fieldbus
(FBA ACT1).
(0) RAW DATA No scaling (i.e. data is transmitted without scaling). Source for the
actual value, which is sent to the fieldbus, is selected by parameter
50.06 FBA ACT1 TR SRC .
(1) TORQUE Fieldbus adapter module uses torque reference scaling. Torque
reference scaling is defined by the used fieldbus profile (e.g. with ABB
Drives Profile integer value 10000 corresponds to 100% torque
value). Signal
1.06 TORQUE is sent to the fieldbus as an actual value.
See the User’s Manual of the appropriate fieldbus adapter module.
(2) SPEED Fieldbus adapter module uses speed reference scaling. Speed
reference scaling is defined by the used fieldbus profile (e.g. with ABB
Drives Profile integer value 20000 corresponds to the value of
parameter
25.02 SPEED SCALING ). Signal 1.01 SPEED ACT is sent
to the fieldbus as an actual value. See the User’s Manual of the
appropriate fieldbus adapter module.
(5) AUTO One of the above selections is chosen automatically according to the
currently active control mode. See parameter group
34 REFERENCE
CTRL .
50.05 FBA REF2 MODESEL FW block: FIELDBUS (see above)
Selects the fieldbus reference FBA REF2 scaling.
See parameter
50.04 FBA REF1 MODESEL .
50.06 FBA ACT1 TR SRC FW block: FIELDBUS (see above)
Selects the source for fieldbus actual value 1 when parameter 50.04 FBA REF1 MODESEL / 50.05
FBA REF2 MODESEL is set to (0) RAW DATA .
Value pointer: Group and index
50.07 FBA ACT2 TR SRC FW block: FIELDBUS (see above)
Selects the source for fieldbus actual value 2 when parameter 50.04 FBA REF1 MODESEL / 50.05
FBA REF2 MODESEL is set to (0) RAW DATA .
Value pointer: Group and index