ABB ACSM1 Series, Руководство по прошивке

Страница: 125 / 334

Parameters and firmware blocks
125
Group 33 SUPERVISION
Configuration of signal supervision.
33
33 SUPERVISION
Firmware block:
SUPERVISION
(17)
Block outputs located in other
parameter groups 6.14 SUPERV STATUS (page 68 )
33.01 SUPERV1 FUNC FW block: SUPERVISION (see above)
Selects the mode of supervision 1.
(0) DISABLED Supervision 1 not in use.
(1) LOW When the signal selected by parameter 33.02 SUPERV1 ACT falls
below the value of parameter 33.04 SUPERV1 LIM LO , bit 0 of 6.14
SUPERV STATUS is activated.
(2) HIGH When the signal selected by parameter 33.02 SUPERV1 ACT
exceeds the value of parameter 33.03 SUPERV1 LIM HI , bit 0 of 6.14
SUPERV STATUS is activated.
(3) ABS LOW When the absolute value of the signal selected by parameter 33.02
SUPERV1 ACT falls below the value of parameter 33.04 SUPERV1
LIM LO , bit 0 of 6.14 SUPERV STATUS is activated.
(4) ABS HIGH When the absolute value of the signal selected by parameter 33.02
SUPERV1 ACT exceeds the value of parameter 33.03 SUPERV1 LIM
HI , bit 0 of 6.14 SUPERV STATUS is activated.
33.02 SUPERV1 ACT FW block: SUPERVISION (see above)
Selects the signal to be monitored by supervision 1. See parameter 33.01 SUPERV1 FUNC .
Value pointer: Group and index
33.03 SUPERV1 LIM HI FW block: SUPERVISION (see above)
Sets the upper limit for supervision 1. See parameter 33.01 SUPERV1 FUNC .
SUPERVISION
45
TLF11 10 msec (6)
33.01 SUPERV1 FUNC
[ Disabled ]
< 33.02 SUPERV1 ACT
[ SPEED ACT ]
(7 / 1.01)
33.03 SUPERV1 LIM HI
[ 0.00 ]
33.04 SUPERV1 LIM LO
[ 0.00 ]
33.05 SUPERV2 FUNC
[ Disabled ]
< 33.06 SUPERV2 ACT
[ CURRENT ]
(1 / 1.04)
33.07 SUPERV2 LIM HI
[ 0.00 ]
33.08 SUPERV2 LIM LO
[ 0.00 ]
33.09 SUPERV3 FUNC
[ Disabled ]
< 33.10 SUPERV3 ACT
[ TORQUE ]
(1 / 1.06)
33.11 SUPERV3 LIM HI
[ 0.00 ]
33.12 SUPERV3 LIM LO
[ 0.00 ]
6.14 SUPERV STATUS