ABB ACS880 Series, Руководство по прошивке

Страница: 623 / 764

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
- / real32 Defines the nominal motor power. The setting must
match the value on the rating plate of the motor. If
nominal power is not shown on the rating plate,
nominal torque can be entered instead in parameter
99.12 .
If multiple motors are connected to the drive, enter the
total power of the motors.
The unit is selected by parameter
96.16 Unit selection .
Note: This parameter cannot be changed while the
drive is running.
Motor nominal
power 99.10
1 = 1 kW or hp / 100 =
1 kW or hp Nominal power of the motor. 0...30000 kW or hp
0.00 / real32 Defines the cosphi of the motor for a more accurate
motor model. The value is not obligatory, but is useful
with an asynchronous motor, especially when
performing a standstill identification run. With a
permanent magnet or synchronous reluctance motor,
this value is not needed.
Note: Do not enter an estimated value. If you do not
know the exact value, leave the parameter at zero.
Note: This parameter cannot be changed while the
drive is running.
Motor nominal cos
φ 99.11
100 = 1 / 100 = 1 Cosphi of the motor. 0.00 ... 1.00
0.000 Nm or lb·ft /
uint32 Defines the nominal motor shaft torque. This value can
be given instead of nominal power (
99.10 ) if shown on
the rating plate of the motor.
The unit is selected by parameter
96.16 Unit selection .
Note: This setting is an alternative to the nominal
power value (
99.10 ). If both are entered, 99.12 takes
priority.
Note: This parameter cannot be changed while the
drive is running.
Motor nominal
torque 99.12
1 = 1 Nm or lb·ft /
1000 = 1 Nm or lb·ft Nominal motor torque. 0.000 ...
4000000.000 Nm or
lb·ft
Parameters 623