ABB ACS880 Series, Руководство по прошивке

Страница: 353 / 764

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
- / - High limit for critical frequency 2. For scaling, see
parameter
46.2 .
-598.00 ... 598.00 Hz
0.00 Hz / real32 Defines the low limit for critical frequency 3.
Note: This value must be less than or equal to the value
of
28.57 Critical frequency 3 high .
Critical frequency 3
low 28.56
- / - Low limit for critical frequency 3. For scaling, see
parameter
46.2 .
-598.00 ... 598.00 Hz
0.00 Hz / real32 Defines the high limit for critical frequency 3.
Note: This value must be greater than or equal to the
value of
28.56 Critical frequency 3 low .
Critical frequency 3
high 28.57
- / - High limit for critical frequency 3. For scaling, see
parameter
46.2 .
-598.00 ... 598.00 Hz
Acc/Dec time 1 /
uint32 Selects a source that switches between the two sets
of acceleration/deceleration times defined by
parameters
28.72 … 28.75 .
0 = Acceleration time 1 and deceleration time 1 are in
force
1 = Acceleration time 2 and deceleration time 2 are in
force
Freq ramp set
selection 28.71
0 0. Acc/Dec time 1
1 1. Acc/Dec time 2
2 Digital input DI1 ( 10.2 DI delayed status , bit 0). DI1
3 Digital input DI2 ( 10.2 DI delayed status , bit 1). DI2
4 Digital input DI3 ( 10.2 DI delayed status , bit 2). DI3
5 Digital input DI4 ( 10.2 DI delayed status , bit 3). DI4
6 Digital input DI5 ( 10.2 DI delayed status , bit 4). DI5
7 Digital input DI6 ( 10.2 DI delayed status , bit 5). DI6
10 Digital input/output DIO1 ( 11.2 DIO delayed status , bit
0).
DIO1
11 Digital input/output DIO2 ( 11.2 DIO delayed status , bit
1).
DIO2
See Terms and abbreviations (page 169) . Other [bit]
20.000 s / real32 Defines acceleration time 1 as the time required for the
frequency to change from zero to the frequency defined
by parameter
46.2 Frequency scaling (not to parameter
30.14 Maximum frequency ).
If the reference increases faster than the set
acceleration rate, the motor will follow the acceleration
rate.
If the reference increases slower than the set
acceleration rate, the motor frequency will follow the
reference.
If the acceleration time is set too short, the drive will
automatically prolong the acceleration in order not to
exceed the drive torque limits.
Freq acceleration
time 1 28.72
Parameters 353