ABB ACS880-17, Руководство по оборудованию

Страница: 73 / 244

Guidelines for planning the electrical installation 73

Requirements table
The following table shows how to select the motor insulation system and when an optional
drive du/dt and common mode filters and insulated N-end (non-drive end) motor bearings
are required. Ignoring the requirements or improper installation may shorten motor life or
damage the motor bearings and voids the warranty.
Motor
type
Nominal AC
supply voltage
Requirement for
Motor
insulation
system
ABB d u /d t and common mode filters, insulated N-end
motor bearings
P
N
< 100 kW
and frame
size <
IEC 315
100 kW < P
N
< 350 kW
or
IEC 315 < frame size <
IEC 400
P
N
> 350 kW
or
frame size >
IEC 400
P
N
< 134 hp
and frame
size <
NEMA 500
134 hp < P
N
< 469 hp
or
NEMA 500 < frame
size < NEMA 580
P
N
> 469 hp
or
frame size >
NEMA 580
ABB motors
Random
-wound
M2_,
M3_ and
M4_ U
N
< 500 V Standard - + N + N + CMF
500 V < U
N
< 600 V Standard + d u /d t + N + d u /d t + N + d u /d t + CMF
or
Reinforced - + N + N + CMF
600 V < U
N
< 690 V
(cable length <
150 m)
Reinforced + d u /d t + N + d u /d t + N + d u /d t + CMF
600 V < U
N
< 690 V
(cable length >
150 m)
Reinforced - + N + N + CMF
Form-
wound
HX_ and
AM_ 380 V < U
N
< 690 V Standard n.a. + N + CMF P
N
< 500 kW:
+N + CMF
P
N
> 500 kW
+N + d u /d t + CMF
Old*
form-
wound
HX_ and
modular 380 V < U
N
< 690 V Check with
the motor
manufacturer.
+ N + d u /d t with voltages over 500 V + CMF
Random
-wound
HX_ and
AM_ ** 0 V < U
N
< 500 V Enamelled
wire with fiber
glass taping + N + CMF
500 V < U
N
< 690 V + N + d u /d t + CMF
HDP Consult the motor manufacturer.
* manufactured before 1.1.1998
** For motors manufactured before 1.1.1998, check for additional instructions with the motor manufacturer.