ABB ACS580-01 drives, Дополнение к руководству по установке

Страница: 22 / 264

22 EN – Main switch and EMC C1 filter options installation supplement
EN
DA
DE
ES
FI
FR
IT
NL
PL
PT
RU
SV
TR
ZH
Tighten the screws to the torque given below the figure.
3. +B056+F278, +B056+F316: Remove the fingerguard off from the main switch by
releasing the clip with a screwdriver (3a) and lifting the fingerguard off (3b).
4. Input cable: Connect the input cable phase conductors as follows. Figure 4 on
page 262 shows a main switch but your drive can have a terminal block instead.
Tighten the screws to the torque given below figures 4 and 5.
•
Ground the shield 360 degrees by tightening the clamp of the power cable
grounding shelf onto the stripped part of the cable (4a).
• Connect the twisted shield of the cable to the grounding terminal (4b).
+B056+F278, +B056+F316:
•
brown phase conductor to terminal 2T1 of the main switch (4c)
• black phase conductor to terminal 4T2 of the main switch (4d)
• gray phase conductor the terminal 6T3 of the main switch (4e).
+B056+E223:
•
brown phase conductor to terminal L1 of the terminal block
• black phase conductor to terminal L2 of the terminal block
• gray phase conductor the terminal L3 of the terminal block.
5. +B056+F278, +B056+F316: Reinstall the finger guard.
6. ACS580-01, ACH580-01 R3: Connect the brake resistor cable (if used). Lead the
conductors under the EMC C1 filter so that they do not make reinstalling the cover
difficult. Tighten the screws to the torque given beside the figure.
7. Install the control cable shelf.
Do according to the R1…R5 quick installation and start-up guide of the drive
• Connect the control cables.
• Install optional modules if any (according to the drive hardware manual).
• Reinstall cover(s).