ABB ACS355 series, Руководство пользователя

Страница: 213 / 436

Actual signals and parameters 213
DI4(INV) See selection DI1(INV) . -4
DI5(INV) See selection DI1(INV) . -5
1607 PARAM SAVE Saves the valid parameter values to the permanent
memory.
Note: A new parameter value of a standard macro is saved
automatically when changed from the panel but not when
altered through a fieldbus connection.
DONE
DONE Saving completed 0
SAVE… Saving in progress 1
1608 START
ENABLE 1
Selects the source for the Start enable 1 signal.
Note: Functionality of the Start enable signal is different
from the Run enable signal.
Example: External damper control application using Start
enable and Run enable. Motor can start only after the
damper is fully open.
NOT SEL
NOT SEL Start enable signal is on. 0
DI1 External signal required through digital input DI1. 1 = Start
enable. If the Start enable signal is switched off, the drive
will not start or it coasts to stop if it is running and alarm
START ENABLE 1 MISSING ( 2021 ) is activated.
The drive can also ramp to stop depending on parameter
2102 STOP FUNCTION .
1
All parameters
No.
Name/Value Description Def/FbEq
Drive started
Start enable
signals
( 1608 and 1609 )
Started
output status
(group 14)
Damper
opening
time
Damper
closed
Damper
closing
time
Damper
status
Relay energized
Damper open
Relay
de-
energized
Damper
closed
Motor
status
Run enable signal
from the damper end
switch when the
damper is fully
opened. ( 1601 )
Acceleration
time ( 2202 )
Deceleration
time ( 2203 )
Motor
speed
Start/Stop
command
(group 10)