background image

1

Items included in the ABB Ability™ Smart Sensor kit:

• 

1  

Clamp-action mounting bracket

• 

2  

Hexagon socket screws (2 qty) M4 x 8 mm

• 

3  

Hexagon socket set screw (1 qty) 1/4" x 5/16" (UNF 28) 

• 

4  

ABB Ability™ Smart Sensor

Where to mount:

1. 

Sensor must be located between the drive-end and non-drive-
end bearings, as close to the center as possible. Note: The sensor 
mount cannot be removed after installation.

2. 

For best Bluetooth® communication, mount the sensor with a 
clear line of sight to any communication devices to be used: your 
smartphone or a Bluetooth® gateway. 

3. 

The mounting orientation must be such that the A-axis on the 
sensor housing is parallel to the rotating shaft. If this is not 
physically possible, the T-axis must be parallel to the rotating 
shaft.

Installation instructions

 

WARNING: 

Direct skin exposure to solvents and/or 

threadlocker could cause discomfort or injury, including but 
not limited to burning or skin irritation. Use appropriate 
protective gloves and goggles when following these 
instructions.  

2

A B B  A B I LIT Y ™  S M A RT  S E N SOR 

I N S TA L L AT I O N  I N S T R U C T I O N S

 1

2

4

2

3

Supported motors

• 

This mounting instruction applies for fin-cooled motors up to frame sizes equivalent to IEC 450. 

• 

Detailed information about which motor types can be monitored with the ABB Ability

TM

 Smart Sensor can be 

found on www.abb.com/smartsensor.

Additional items needed but not included in the kit:

• 

Degreasing agent

• 

Rubber gloves

• 

Safety goggles

• 

Allen wrench (3 mm or 1/8") 

• 

Loctite™ Blue Threadlocker

• 

Loctite™ 454 or similar glue

Items needed

Содержание Ability

Страница 1: ...caution could result in bodily injury CAUTION Do not replace batteries Incorrect use of batteries may void the certifications of the Smart Sensor such as hazardous area certifications safety certifications and IP rating Dispose of used sensors according to instructions This instruction sheet provides information on the installation of ABB Ability Smart Sensor with clamping bracket Read these instr...

Страница 2: ...shaft If this is not physically possible the T axis must be parallel to the rotating shaft Installation instructions WARNING Direct skin exposure to solvents and or threadlocker could cause discomfort or injury including but not limited to burning or skin irritation Use appropriate protective gloves and goggles when following these instructions 2 ABB ABILITY SMART SENSOR INSTALL ATION INSTRUCTIONS...

Страница 3: ...FACTURER S INSTRUCTIONS AND SAFETY PRECAUTIONS WHEN USING GLUE Step 2 Degrease the upper and lower surfaces of the selected fin at the recommended mounting position Step 3 Apply LoctiteTM 454 glue or similar to the clamping bracket legs before attaching it to the fin Step 4 Clamp the mounting bracket onto the cooling fin of the motor Step 5 Use a hammer with a rubber or plastic head to assist with...

Страница 4: ...unting bracket For questions and support please contact ABB Motors and Generators Service Product information www abb com smartsensor Support e mail address support smartsensor abb com CAUTION REVIEW AND FOLLOW ALL MANUFACTURER S INSTRUCTIONS AND SAFETY PRECAUTIONS WHEN USING MOUNTING THREADLOCKER NOTE We reserve the right to make technical changes or modify the contents of this document without p...

Отзывы: