ABB 8241, Руководство по эксплуатации

Страница: 8 / 28

6
6 PROGRAMMING
Fig. 6.1 Location of Serial Data Interface Page
The general programming procedure is as detailed in the relevant Instruction Manual, but with an additional
Set Up Serial Interface
frame in the
Set Up Instrument
page.
6.1 Serial Interface Page
Refer to Section 6.3 (Set Up Instrument) in the relevant Instruction Manual.
CLOCK SETUP. PAGE 3.2
Date (DD/MM/YY) = xx/xx/xx
Time (HH:MM) = xx:xx
SET UP INSTRUMENT PAGE 3.1
Software issue = x
Control temperature = xx.x‘C
Display units = <units>
Display units as = xxx
Alter setup security code = xxxx
SET UP INSTRUMENT PAGE 3.0
Enter security code xxxx
xx/x
xxxxxxxxxxx
Page 0
DIAGNOSTIC INFORMATION PAGE 1.0
Next 5 weekly service = DD/MM
Next yearly service = DD/MM/YY
Monitor in service
MAINTENANCE AND CALIBRATION. PAGE 2.0
Enter security code xxxx
SET UP CURRENT OUTPUTS PAGE 4.0
Output range 1 = 0 to xxx <units>
Calibration hold = NO
Output range 2 = 0 to xxx <units>
Calibration hold = NO
Output type = xx to xx mA
Test output = NO
SET UP SERIAL INTERFACE PAGE 3.3
Baud Rate = xxxx
Parity = xxxx
ID = xx
SET UP SERIAL INTERFACE PAGE 3.3
Baud Rate = xxxx
Parity = xxxx
ID = xx
Baud Rate
Select the transmission rate required (1200 slowest, 9600
fastest).
Parity
Select the appropriate parity (None, Odd or Even) to match the
computer terminal or host computer.
Transmitter Identification
Assign the transmitter an identification number (1 to 99) – see
Section 4.1. The identification number allows more than one
transmitter to be accessed via the communication channel.