ABB 2RCA035147, Руководство по эксплуатации

Страница: 15 / 24

15
—
7.2 Vertical cut Alternative B (left/right)
To set the cutting head for vertical left guiding:
turn the cutting head so that the “VERTICAL Left”
marking is at the top.
Use the “VERTICAL Left” position with cuttings (6-9)
as shown in section 2 (alternative B).
Make four cuts (6-9) below each other.
It is recommended to make overlapping cuts to avoid
sharp edges in between the cutting junction points.
Push the cutting head firmly against the left side
cut-out edge starting from the top.
For the last vertical cut, push the cutting head
firmly against the left side cut-out edge as shown
in the picture.