Abatronic AMB-12H, Инструкция по эксплуатации

Страница: 22 / 22

- 21 -
2. Damaged plug or socket
3.Fuse(s) broken or wire
broken. socket;
3. Change the fuse (Spec
3.15A/250VAC). Or mains
fuse 13A. Replace mains
wire if damaged
The unit stops running
automatically
Timer is operating or room
temperature is lower than set
temperature.
Switch off the Timer. Wait for
the unit to run
automatically or re-set
temperature.
No cool air coming out
under cooling mode
1. Room temperature is lower
than set temperature.
2 There is frost on the
evaporator. 1. Re-set temperature.
2. The unit is defrosting and
it will run after defrosting is
finished.
No warm air coming
out under heating
mode
1. Room temperature is higher
than set temperature.
2 The unit is defrosting.
3. The indoor temperature is too
low and causes anti-frozen
protection on. 1. Re-set temperature.
2. Wait until defrosting
finished.
3. Wait until indoor
temperature rises and the
unit runs automatically.
Error code“E2”showed
on the LCD. Indoor temperature sensor out
of order or damaged.
Change the indoor
temperature sensor
Error code“E3” showed
on the LCD. Indoor coil sensor out of order
or damaged.
Change indoor coil sensor.
Error code“E4”showed
on the LCD.
Water storage tank is full Drain water tank properly.
Error code“E5”showed
on the LCD. Outdoor coil sensor out of order
or damaged.
Change outdoor coil sensor
“ ” flashing
Defrosting
Normal display during
defrosting.
8 Packing List
No Description Qty
1 Air Conditioner Unit 1
2 Unit mounting bracket 1
3 Instruction Manual 1
4 Remote Controller 1
5 Air Duct 2
6 Air Duct Cover(including atomization device, tube and connector) 2
7 Spring retaining ring 2
8 Spring 4
9 Plastic wall plugs 12
10 Screw 10
11 Screw 4
12 Bottom cover panel 1
13 Installation wall mounting Template 1