AAT Holding KaDe KDH-KZ620H, Руководство по установке

Страница: 7 / 28

Integrated Access Controller – Installation manual
All rights reserved. © AAT HOLDING S.A.
7
Add Common Users
Programming Step Keystroke Combination
1. Enter Program Mode * (Master Code) #
Add Card User
2. Add Card: Using Auto ID
(Allows controller to assign Card to next avail-
able User ID number)
OR
2. Add Card: Select Specific ID
(Allows Master to define a specific User ID to
associate the card to)
OR
2. Add Card: by Card Number
OR
2. Add Card: Block Enrolment
(Allows Master to add up to 598 cards to the
Reader in a single step.)
Takes 2 minutes to program.
1 (Read Card) #
The cards can be added continuously.
1 (User ID) # (Read Card) #
(User ID is any number from 1-598)
1 (Input 8/10 digits Card number) #
1 ( User ID) # (Card quantity) # (The
first card number) #
Cards’ number must be consecutive;
Card quantity = number of cards to be en-
rolled.
Default PIN - 8888 is assigned to each new
card.
Add PIN User
2. Add PIN: Using Auto ID
(Allows controller to assign PIN to next availa-
ble User ID number)
1 (PIN ) #
The PINs can be added continuously.
(PIN: 4~6digits)
2. Add PIN: Select Specific ID
(Allows manager to define a specific User ID
to associate the PIN to)
1 (User ID) # (PIN ) #
The user ID is any number from 1-598.
3. Exit *
Add Panic Users
Programming Step Keystroke Combination
1. Enter Program Mode * (Master Code) #
2. Add Card:
OR
2. Add PIN:
1 (User ID) # (Read Card / Input 8/10
digits Card number) #
1 (User ID) # (PIN ) #
(User ID is any number from 599-600)
3. Exit *
Change PIN Users
Programming Step Keystroke Combination
Note: Below is done outside programming mode, users can undertake this themselves
2. Change PIN: By Card
(There will auto allocate PIN(8888) to cards
when adding)
* (Read Card) (Old PIN) # (New PIN) #
(Repeat New PIN) #
2. Change PIN: By PIN
* (User ID) # (Old PIN) # (New PIN) #
(Repeat New PIN) #
3. Exit
﹡