DBC 422
AND
DBC 425
19
1531-DBC 422 02 Uen B3 2013-12-02
To change the IP settings, enter the administrator mode before the timer
x is counted down to zero. If the administrator mode is not entered, or
No change
(F4) is pressed, the currently stored settings will be used and
the
Getting configuration file
menu is shown.
If the procedure for administrator mode is entered, the following menu
appears:
Figure 34:
If fixed IP addresses will be used, verify that the value for DHCP is No.
For a complete survey of all menus in the Network settings, 7.34.5
Change IP settings in DBC 425 on page 73.
Enter the necessary IP settings.
Press
Exit
(F1) to continue the boot procedure.
After this, the start up sequence is similar to the one when using DHCP,
see 7.3.1 Starting a DBC 425 phone in a LAN with a DHCP server on
page 14.
7.3.3
Update of the software in the IP phone
This section is reached from the section, 7.3.1 Starting a DBC 425 phone
in a LAN with a DHCP server on page 14 or from the section 7.3.2 Manu-
ally setting of the fixed IP addresses on page 18.
Two types of updates may be performed on the IP phone:
•
Update of both the application software and the bootROM.
•
Update of only the application software.
Note:
It is not possible to only update the boot software. If the boot soft-
ware will be updated, the application has to be updated as well.
The following menu appears if a new bootrom shall be loaded:
