Aastra BLUESTAR 8000I, Руководство администратора режима PBX

Страница: 36 / 143

Configuration Server
41-001390-00 Rev 02 – 12.2011
2-4
Configuration Server
Configuration Server Protocol
You can download new versions of software and configuration files from the configuration server to the BluStar 8000i
using any of the following types of protocols:
• TFTP
• FTP
• HTTP
• HTTPS
For each protocol, you can specify the path for which the configuration files are located on the server.
For HTTP and HTTPS you can also specify the port number to use for downloading the BluStar 8000i configuration files.
For FTP you can configure a username and password that are authenticated by the FTP server.
When loading the <user>.cfg and csv files, FTP uses the username and password from the FTP URL in the configuration
file. If a password is not provided, it tries anonymous access.
Configuration Server Settings
The configuration server stores the configuration files and the software to perform software upgrades to the BluStar 8000i.
A system administrator can configure the parameters listed in the table below for the configuration server set for loading
the aastra.cfg, <model>.cfg, and <mac>.cfg files. For loading the <user>.cfg file, the “
user config url ” parameter is used.
Note:
The configuration server can be configured from configuration files (see Configuration Server Settings on page 2-4 ),
DHCP (see DHCP on page 3-2 ), and from the BluStar 8000i UI (see Terminal Identity on page 4-2 ).
Parameters in Configuration Files Description
Download Protocol Setting
download protocol Protocol to download configuration files. Valid values are:
TFTP
FTP
HTTP
HTTPS
For example, download protocol: HTTP
For DHCP to automatically populate the IP address or domain name for the download servers, your DHCP
server must support Option 66. For more information, see
DHCP
on
page 3-2.
download timeout Specifies the overall timeout (seconds) for downloading the configuration files (aastra.cfg, <model>.cfg, and
<mac>.cfg).
For example, download timeout: 30
pbx mode Specifies if the BluStar 8000i is in PBX mode.
For example, pbx mode: 1
update url The URL to upgrade the BluStar 8000i software.
For example, update url: http://10.55.102.56/aastracfg/sfour-3.9.0-pre52-pbxmerge@2011.03.24.1540
Notes:
•
The software upgrade action will only be done on the first reboot after the parameter has been modified.
• This parameter does not support TFTP.