Page 5 American Access Systems / Security Brands, Inc.
STEP 2-SYSTEM CONNECTIONS HOOKUP STEPS
(A). Make all your prox slave connections BEFORE you apply power to the master unit. To connect power to your
new post mount unit plug the tranformer into an outlet and connect the other end to the power plug on main circuit
board.
(B). Connect the device(s) to be controlled to the appropriate terminal(s).
(C). Double check your connections. When you are sure you have the unit hooked up correctly, apply power to the
unit. If this is the first time power up, the unit will perform some self diagnostics and setup the memory. The unit will
flash the LED’s several times while it is performing the first time setup. If everything goes O.K., you will hear a GOOD
BEEP from the unit. If the unit does not perform as above, quickly turn off power to the unit and contact American
Access Systems.
NOTE: THE UNIT WILL ONLY PERFORM THE SELF DIAGNOSTICS AND MEMORY SETUP THE FIRST TIME IT IS POWERED UP.
FROM THERE ON OUT THE UNIT WILL SOUND A GOOD BEEP IMMEDIATELY AFTER POWER IS APPLIED.
STEP
2 -SYSTEM
CONNECTIONS
HOOKUP STEPS
COMMUNICATIONS & RELAYS
PRINTER POWER HOOKUP
