SPEAKER PLACEMENT
(IF USED FOR SURROUND SOUND)
With an audio visual sound system “surround sound” speakers have to be placed in certain
positions to obtain the best surround sound effect. However the system must also fit in with your
room layout and decor, so more often than not the following recommendations can`t be followed
to the letter. Still, our advice is to stick as close as possible to the guidelines below.
Surround sound speakers should be placed one each side of your listening position at
approximately ear height or higher. It is also common to place them behind the listening position
each side of the room at ear height or higher. Both positions will give you excellent results but it is
worthwhile to note that the film has been recorded assuming the sound will come from the sides.
CARING FOR YOUR SPEAKERS
●
Periodically wipe the cabinets and grills with a damp cloth using a mild detergent.
●
Vacuum the grill with the brush attachment on the vacuum cleaner from time to time.
●
If the speakers are located in a salt prone area, you can further protect the grills, bracket and
terminals by spraying them with silicone regularly.
●
Never use more than a small adjustment on your tone controls especially at high volumes.
●
Turn down the volume when changing a record or switching from one source to another.
●
Whenever changing wires, plugs, etc always turn all equipment off.
●
When you get your speakers check that they have not been damaged in transit. Please keep
the original cartons in case of future need, they fold flat and take little space.
●
Don`t push in the diaphragms with any force.
●
Do not expose the diaphragms to direct sunlight.
●
Do not spray a hose directly at the front of the speaker.
●
Don`t use solvents to clean any part of the speaker.
●
Consult with your Hi Fi specialist before connecting more than one speaker to each output of
your amplifier.
●
Never connect your speakers to the electricity mains.
●
Tampering with the internal parts of the speaker may cause damage not covered by
warranty.
●
If a part fails, insist on a genuine replacement.
●
Do not put your ears too close to the speakers or play them too loud for extended periods of
time, as this may cause partial hearing loss.
THINGS TO BE CAREFUL OF
SPECIFICATIONS
Specifications:
Frequency Response
Recommended Amplifier Power
Sensitivity
Nominal Impedance
Crossover Frequency
Tweeter
Woofer
Cabinet Dimensions
Enclosure Finish
Weight
SAT - 60
90Hz - 20Hz 3db (Free Field)
20 - 100 watts Per Channel Undistorted
87 db
8 ohms
5 kHz
13 mm Dome
146 mm Carbon Impregnated Polypropylene Cone
245mm H x 160mm W x 130mm D
White or Black
2 kgs
+
-
+