AAQ AutoLift AL-900DD, Руководство по установке и инструкции по эксплуатации

Страница: 18 / 34

7.5 Installation procedure
1. Carriage
2. Shaft
3. 3-stage arm
4. Long hose
5. Side plate of bottom
bar
6. Bottom bar
7. Solenoid power line
8. Balance cable
9. Column
10. Pump hose
11. Protector
12. Motor
13. cable pulley bracket
14. Long arm
Install Procedure:
1) Unpack lift, attach control box and power pack to main power post.
2) Attach pulley brackets to the top of both posts. Be careful install bracket with pulley offset to the
left, fit to power post.
3) Stand up and position both posts. Route balance wire ropes, do not tighten at this stage. Connect
hydraulic hose between posts, and main hose from manifold to bottom of power post hydraulic ram
fitting.
4) Using base plate cover, move posts in or out for best fitment internal post and external post
dimensions supplied are a guide only.
5) Drill, bolt and shim level both posts, using M20 tru-bolts supplied. Tighten to a
minimum 150nm of torque.
6) Attach electrical cables: From control box to motor refer, to power post limit switch, safety
lock solenoid cable.
7) Electrician to connect to mains supply.
8) Bleed air from hydraulic system ie: Loosen hydraulic hose on slave post, press up
button and bleed into container.
9) Adjust balance cables, so both carriage locks engage at the same time.
10) Adjust hydraulic pressure valve to 120-150bar.
11) Lift is ready for use.
18