9
Installation, Operation and Parts Manual
AutoLift AL-6254
Step 10: Connect electrical wires.
Attention: Only licensed electricians are allowed to carry out electrical connection.
1.
Mount the control box on to the power side post.
2.
Connect the limit switch inside the power‐side post.
3.
Connect motor wire and power suppply cable including the top limit switch wire to the control box .
Step 11: Install lifting arms.
Install the lifting arms on the carriage by 38mm pins. NOTE: Long arms are to the rear of the vehicle.
Step 12: Fill Oil Tank.
Oil tank volumn is 10L. Normal work should have 80% oil inside the tank.
Usually the hoist needs 13 litres of hydraulic oil. Fill about 10 litres into the oil tank then run the hoist up and down 2 or 3 times.
Refill the remainder 3 litres of oil. It is suggested to use 32#anti‐abrasion hydraulic oil.
top limit switches
motor cable connect to the
control box
