- 7 -
Wall Mounting (if using option-B)
Note:
- Installation must be carried out by qualified personnel only. Incorrect assembly can result in severe
personal injury and property damage (if you intend to install this product yourself, you must check
for installations such as electrical wiring and plumbing that may be buried inside the wall). It is the
installer’s responsibility to verify that the wall will safely support the total load of the unit and wall
brackets.
- Additional tools (not included) are required for the installation.
- Do not overtighten screws.
- Keep this instruction manual for future reference.
- Use an electronic stud finder to check the wall type before drilling and mounting.
1. Remove the backing paper from the rubber. Stick the rubber to the back of the soundbar.
NOTE:
Ensure the surface is clean prior to sticking the rubber to the back of the soundbar.
2 Drill 2 parallel holes (Ø 3-8 mm each according to wall type) in the wall. The distance between the
holes should be 711 mm . Firmly fix 1 dowel into each hole in the wall if necessary.
3 Leave a 9 mm gap between the wall and the screw’s head. Lift the soundbar over the heads of the
screws and slot into place.
Dowel
Solid wall (i.e ., Solid brick,
Solid concrete , Solid wood,
Solid wooden battens)
Drywall, Plaster wall,
Lath wall, etc.
711 mm
1
2
3
Connections
Use the OPTICAL Socket
Remove the protective cap of the OPTICAL
socket, then connect an OPTICAL cable
(included) to the TV’s OPTICAL OUT socket
and the OPTICAL socket on the SoundBar.
• The digital optical connector might be
labeled SPDIF or SPDIF OUT.
AC
~
56:/)'2
