![background image](http://html1.mh-extra.com/html/aandd/ua-851ant/ua-851ant_instruction-manual_3122684011.webp)
E-7
3. Secure cuff around arm. The cuff should be snug but
not too tight. You should be able to insert two fingers
between the cuff and your arm.
2. Lay left arm on the table, palm up and thread cuff end
through metal loop, smooth side against arm. Then
position the tube off-center toward the inner side of arm
in line with your little finger.
TAKING YOUR BLOOD PRESSURE
4. Confirm that the Index Mark
points within the
proper fit range.
5. Press the START button. As the cuff pressurizes,
measurement will begin and the Cuff Inflation Meter will show on the display
screen. It is normal for the cuff to feel very tight.
Note: If an appropriate pressure is not obtained, the device automatically starts
to inflate again.
Note: If you wish to stop inflation at any time, press the START button again.
6. When the measurement is complete, the systolic and diastolic pressure readings
and pulse rate are displayed. The cuff deflates and the monitor automatically shuts
off after 60 seconds, or you can turn it off by pressing the START button. Your
measurement is automatically stored in memory (the monitor can store up to 50
readings in memory).
7. The monitor automatically transmits your readings wirelessly if it is within range of
an active receiver. If the monitor is not in range, the data will be stored in memory
until the blood pressure monitor is activated in range of an active receiver. The
UA-851ANT can store up to 50 measurements.
IMPORTANT: Measure blood pressure at the same time each day.
IMPORTANT: The range of the UA-851ANT may be affected by walls, materials
around or between the UA-851ANT and receiver, and other environmental factors.