A&D RA3100 Omniace, Инструкция по эксплуатации

Страница: 110 / 176

9.Using Optional Modules - 9.4.16 Channel Logic Module (RA30-105)
110 1WMPD4004444
9.4. 16 Channel Logic Module (RA30-105)
9.4.1. Overview
This module is a logic module that converts 16 channels (8 channels x 2) of input signals into H or L
logic signals according to a threshold. It supports voltage (high/low) detection and non-voltage contact
(open/close) of input signals. Pulses can respond at 1 μs or lower. 16 channel data synchronizes for
measurement and recording. The probe that can connect to this module is an optional 1539S floating
voltage probe for recording the existence of 100 V or 200 V system voltage and the 1540S and 1543S
voltage conversion probes for recording voltage increases and decreases for AC 100 V systems and AC
200 V systems.
9.4.2. Setup the Input Channel
The Input signal setting of this module differs for voltage and contact, as indicated below.
<Voltage input> <Contact input>
(1)
(2) (2)
(3) (3)
(4) (5)
(6) (7) (6) (7)
(8) (9)
(10)
(11)
(1) Slot number, input module type
(2) Change slot: You can change the display slot by swiping this sub menu left or right or tapping the
left < and right > key.
(3) Select channel: Tap CHA and CHB in the slots and select the channel.
(4) Meas. ON/OFF
ON: Measure and record the input signal.
(5) Color: Change the display color of the waveform monitor.