8
/10
3-2. Setting the Projector
3D sync polarity depends on the settings of server and projector.
[Figure 3-2. Christie CP2000, 3D-set-up UI]
1. Connect HD projector to 3D server and operate. (Please
refer to the manual for more information.)
2. Upload the film, finish all the steps and be ready to push the
“play” button on the
server. (Projector is in the process of 3D sync signal output.)
3. Set up the 3D mode on the HD projector.
4. Recommended dark time setting is 400µs.
3-3. Start and Ending Film
3-3-1. Starting
1. Set up the server and projector in waiting mode. Just push the "play" but- ton, then
the 3D film will begin to operate.
2. Check the USB cable connection.
3. Turn the power on using the power button on the setting panel. Then you will see the
red LED on. Start the 3D film by pushing the play button on the digital server.
4. If L/R shows reverted on the projector, use the L/R button to correct the problem.
3-3-2. Ending Film
1. End the operation of HD projector and 3D server.
(Refer to the projector and server manual for more information.)
2. Push the power off button. 3D-filter will stop operating.
