Operators and Maintenance Manual
Display
EEM MOT 01 FE03.04
Page
6/16
Copyright:
Auto & Aero Technologies Sp. z o.o.
Mazowiecka 10/5, 20-723 Lublin, Poland
■
email: [email protected]
■
www.aatech.pl
3.3. Mounting
The display should be located conveniently
within the pilot’s view
in the
control panel in the cockpit. The diameter of the mounting hole to be cut
in the panel is 80mm. It is recommended that the display is installed from
the rear side the control panel. The display is to be fastened to the panel
by means of four M3 screws that are located symmetrically to the centre
of the mounting hole in the spacing of 62.9 mm (Fig. 3).
Fig. 3. Mounting hole and screw holes measurements (not to scale)
3.4. Power and wiring
The EEM MOT 01 display is powered from the aircraft power system.
Power specifications: nominal supply voltage 12V, acceptable supply
voltage range 8
÷
30V, current < 85mA.
