S- & D-Type / EN
Seite 2/4
Version-5
Draft2Go S- & D-Type/ Well & Draft
Dispensing Unit from DSI for Schäfer-Kegs
General
The dispensing unit offers a compact and simple solution for mobile dispensing from a keg. For this purpose, the suitable
dispensing head is installed with an already preset pressure reducer incl. quick-connect coupling for the gas supply from the
pressure tank (7 bar) of the keg and a compensator dispensing tap. For operating the Draft-2-Go Tap unit you need basic
knowledge of tapping beer and you have to respect to mentioned details in this instruction. For Service or repair of the unit, ask
us or a qualified dispense system technician.
Installation
Before initial startup, you must rinse the components under clean water to remove any production residues. To do this,
thoroughly rinse the dispense head (1) and the tap (2) in the beverage-touched areas as shown. (see chapter: Cleaning/Service)
To assemble your D2G dispensing unit, proceed as follows: Take the dispense head (1) incl.
pre-mounted pressure reducer (4) out of the packaging and mount the tap incl. shank (2)
on the side outlet of the dispense head (1). The alignment of the tap can be done later at
the knurled nut between tap and shank. Now take the plug-in coupling (3) incl. pre-
assembled gas line and push the end of the line into the connection on the pressure reducer
(4).
Do not connect any gas supply other than the gas supply located in the keg and intended
for this product.
Instruction manual
Now you can put the dispensing unit into operation. To
do this, place the dispense head (1) into the keg from
above by aligning the two notches. Then turn it clockwise
against the stop so that it is locked on the Keg. To align
the tap (2), you can swivel it to the left/right. Then push
the plug-in coupling (3) onto the gas supply on the keg
until it fits. To do this, pull up the outer ring of the plug-
in coupling (3) and push it all the way down. The unit is
now automatically supplied with gas and regulated to the
required pressure. Please check the gas-carrying
connection points for leaks. The dispense head (1) can
now be attached to the keg to start dispensing. To do
this, move the handle of the dispense head (1)
completely to the lower position until it locks into place.
Be careful not to squeeze yourself during the operation.
The beverage is now pressurized and ready for
dispensing. To remove the unit, proceed in reverse order.
To tap the beverage/beer you can now start directly, thanks to the fixed gas pressure.
Make sure that the keg is securely positioned so that it does not fall over when tapping.
