Aaeon GENE-6310, Руководство пользователя

Страница: 67 / 98

58 GENE-6310 User Manual
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install
an add-in FDC or the system has no floppy drive, select Disabled
in this field.
The choices: Enabled, Disabled.
Onboard Serial Port (1, 2)
Normally, the main board I/O chips will occupy a certain portion of
memory space. For each I/O device the computer provides an I/O
address. The more devices attached the more address needed to
organize the memory storage areas. If all the I/O devices were run
through the same address, your devices would come to a near halt.
By providing the end user with four serial ports this allows devices
to run more efficiently if needed. Also the
corresponding interrupt
needs to be selected.
Selections of logical COM port addresses are as follows. ( 3F8/
IRQ4, 3E8/IRQ4, 2F8/IRQ3, 2E8/IRQ3)
The choices: Enabled, Disabled.
UART 2 Mode
Select an operating mode for the second serial port:
Normal
RS-232C serial port
Standard
RS-232C serial port
IrDA 1.0
Infrared port compliant with IrDA 1.0
specification
IrDA SIR
IrDA-compliant serial infrared port
IrDA MIR
1 MB/sec infrared port
IrDA FIR
Fast infrared standard
FIR
Fast Infrared standard
MIR 0.57M
0.57-MB/sec infrared port
MIR 1.15M
1.15-MB/sec infrared port
Sharp IR
4-MB/sec data transmission