![background image](http://html1.mh-extra.com/html/aaeon/emb-830/emb-830_manual_3215217026.webp)
E m b e d d e d A T X B o a r d
E M B - 8 3 0
Chapter 2 Quick Installation Guide
2 - 13
2.15 COM6 Ring/+5V/+12V Selection (JP10)
JP10
Function
1-2
+12V
3-4
+5V
5-6
Ring (Default)
2.16 COM5 Ring/+5V/+12V Selection (JP11)
JP11
Function
1-2
+12V
3-4
+5V
5-6
Ring (Default)
2.17 EIDE Connector (IDE1, IDE2, and CN1)
You can attach up to four Enhanced Integrated Device Electronics
hard disk drives to IDE1, IDE2, and CN1. The IDE controller of
EMB-830 uses a PCI local bus interface. This advanced interface
supports faster data transfer. You can use either IDE2 or CN1 at the
same time.
Connecting the hard drive
Wire number 1 on the cable is normally red or blue, and the other
wires are usually gray.
1. Connect one end of the cable to CN1. Make sure that the red
wire corresponds to pin 1 on the connector.
2. Plug the other end of the cable to the Enhanced IDE hard drive,
with pin 1 on the cable corresponding to pin 1 on the hard drives.
(See your hard drive's documentation for the location of the
connector).
Connect a second drive with another connector on the cable as
described above.
Содержание EMB-830
