SAWTOOTH
PUSH
PUSH
1
2
3
4
SAWTOOTH/D-RING PICTURE HANGING
INSERT MAGNEKEYS
Remove the MAGNEKEYS and insert into sawtooth,
D-Ring, or our SINGLE-NOTCH PRECISION HANGERS.
1
EXTEND & HOOK
Press CENTER BUTTON to extend the
base. Suspend the frame wire on the
BUILT-IN HOOKS, then position and LEVEL
picture. Use the two, outer HOOKS for
heavier frames and the single HOOK for
lighter frames.
MARK HOLES
Pressing firmly against the wall, remove
your frame from the HOOKS . Locate the
removable PUSH PIN (located beneath
the LEVEL) and mark nail holes through
the HOOK guide holes.
2
LEVEL & MARK HOLES
Place removable LEVEL on top edge of the frame.
Position and level frame on wall, then firmly push
directly over hangers to mark your nail holes.
INSTALL HARDWARE
Locate the marks on the wall made by MAGNEKEYS.
Install nails straight into the wall marks.
HANG YOUR PICTURE
3
4
INSTALL HARDWARE
Locate the marks on the wall made by the
PUSH PIN. Install picture hook hardware.
HANG YOUR PICTURE
WIRE PICTURE HANGING
See it in action at
GoHangIt.com
@gohangit
@go.hang.it.
Works with most picture hanging hardware.
Suggested weight limits:
Nails in wood studs - 50 lbs
Nails in drywall - 10 lbs
!
D-RING
