5
Programming for an Installation WITH Local Wireless Keys
x
The 6150RFAAA is supplied with default settings for the functions of the wireless keys. See page 3.
x
If, during the programming of wireless keys, you make a wrong entry and want to reprogram a wireless
key, simply press the [
✱
] key until “d-“ is displayed. Then enter the correct information.
Perform steps 1-6 in the
Programming for an Installation Without Local Wireless Keys
section
.
Then perform
the following steps:
Step Action
Display
1
Enter [3] (House ID). Enter the 2-digit House ID for the
6150RFAAA (01-31).
Note:
The House ID is needed only if RF keypads and/or
bidirectional units are used and House ID source is set for
Local.
The House ID entered here
MUST
match the House ID
programmed in the RF keypad and the bidirectional unit.
Press the [
✱
] key to continue.
Alternately flashes “hl” and a
2-digit number.
2
Enter [8] (Wireless Key Auto Enroll). The 6150RFAAA
automatically advances to first available device number.
Note:
If all 8 devices have been enrolled, the 6150RFAAA beeps three
times and continues to alternately flash "oo" and "--."
Alternately flashes "d" with
the device number; and “--.”
3
Press any button on the wireless key to enroll the serial number.
Note:
If enrolling a wireless key (5804E) in High-Security mode,
press all four buttons on the wireless key simultaneously.
Alternately flashes "d" with
the device number; and the
serial number.
4
Press the [
✱
] key to accept the serial number; OR press the [
✱
] key
to reject the serial number.
If you accept the serial number, the 6150RFAAA beeps twice. If you
reject the serial number, the 6150RFAAA returns to the “enroll
serial number” prompt.
Note:
A maximum of 8 wireless keys may be enrolled into the
6150RFAAA. These wireless keys
DO NOT
occupy any zones
supported by the control.
If you are finished programming for now, press
[
✱
]
to exit.
Otherwise, continue with step 5.
If you accept the serial
number, the display flashes
the device number and a
hyphen.
If you reject the serial
number, the display
alternately flashes "d" with
the device number; and “--.”
5
Enter [2] (User Code). Enter the 4-digit user code for the wireless
key.
Note:
The user code must be a valid code that is programmed in the
control panel.
Press the [
✱
] key to accept the user code.
If you are finished programming for now, press
[
✱
]
to exit.
Otherwise, continue with step 6.
Flashes "u4." Once the 4-digit
user code is entered, the
display flashes "u4," the first
two digits, and then the last
two digits of the user code.
