I
I
N
N
T
T
R
R
O
O
D
D
U
U
C
C
T
T
I
I
O
O
N
N
Congratulations on your purchase! Your new RF-Mouse is easy to install and offers you a host of
useful features. The Radio receiver can be conveniently placed to give you the freedom you need
while working. The vertical wheel allows you to scroll, or zoom in and out in a document. It is
included with 2-wheels and 3-buttons. You can program the mouse buttons to launch the NetJump
or LuckyJump for a quick start to programs you run frequently. And, your RF-Mouse has a unique
ID code, so other RF (Radio Frequency) pointing devices won’t affect your system.
Connecting the RF-Mouse Receiver
The RF-Mouse receiver connects to your computer in
the same way as a conventional mouse allowing you to
place the receiver wherever is convenient on your
desktop.
1.
Locate the round 6-pin PS/2 mouse port on the back of
your computer.
2.
Insert the PS/2 connector into the PS/2 port.
Locating the RF-Mouse Receiver
Your RF-Mouse has limitations on the range or distance from the
receiver. To make sure that your mouse sends and receives properly,
refer to the following:
1.
For optimal performance, place the receiver at least 8 inches (20
centimeters) away from other electrical devices, such as the
computer, the monitor, or external storage drives.
2.
The RF-Mouse should be no farther than 3.3 feet (1.0 meter) from
the mouse receiver. This will ensure optimal communication between
the mouse and receiver.
3.
If you are working on a metallic surface, try using a mouse pad and
turning the receiver face down for better reception.
4.
Switch frequency channels to prevent interference from other RF
pointing devices. (See the following section for more information.)
Selecting the Frequency Channel
The RF-Mouse operates on two
frequency channels. To prevent
interference when using two RF
Mice in close proximity a different
frequency channel should be used
for each mouse. Refer to the
following to change the frequency
channel for your mouse:
1.
Set the frequency channel on
the receiver to
1
or
2.
2.
Remove the battery cover from
the mouse (see the following
Inserting the Batteries
section).
3.
Set the frequency channel on
the mouse to
1
or
2.
(The
frequency channel for mouse
and receiver must be the same.)