— 3 —
Selecting the Frequency Channel
The RF-Mouse operates on two frequency channels. To prevent interference when using two RF
Mice in close proximity a different frequency channel should be used for each mouse. Refer to
the following to change the frequency channel for your mouse:
1.
Set the frequency channel on the receiver to
1
or
2.
2.
Remove the battery cover from the mouse (see the following
Inserting the Batteries
section).
3.
Set the frequency channel on the mouse to
1
or
2.
(The frequency channel for mouse and
receiver must be the same.)
Inserting the Batteries
The RF-Mouse uses two AA batteries. For best performance, use only alkaline batteries. Refer to
the following to insert the batteries:
1.
Press the tab on the bottom of the mouse cover as shown here and remove the cover.
2.
Insert the two AA batteries. (The correct polarity is indicated on the battery
compartment casing.)
3.
Replace the cover.
Checking the Batteries power
To check the battery power, right-click the mouse icon
in the Taskbar.
Choose the “Check RF-Mouse Status” option to display the RF-Mouse
Status window. The current battery percentage charge is shown.
Installing the Mouse Software
Before you can take advantage of the many features your mouse offers, you must install the driver. The driver is
on the installation diskette that came packaged with your mouse.
Windows 95/98/2000/NT4.0/ME/XP installation
1.
Connect the mouse to your computer.
2.
Insert the installation diskette into your floppy disk drive.
3.
Click the
Start
button and then click
Run
.
4.
In the
Run
dialog window, type
A:\setup
, where “A” is the letter of your floppy disk drive.
5.
Click
OK
and follow the instructions on your screen to complete the installation.
The RF-Mouse ID code
Each RF-Mouse is assigned a unique ID code at manufacture, so the receiver only picks up the signal from your
mouse and prevents other RF-Mouse radio signals from operating on your computer. This feature can also be
disabled, allowing other RF-pointing devices to operate your computer.
Connecting the RF-Mouse ID Code