a2b A2B Galvani, Руководство пользователя

Страница: 29 / 38

29 page
owner´s manual
Removing rear wheel
1.
Ensure that the battery is disconnected.
2. Remove the cable retaining clips using an ap-
propriate allen keyalso located on the underside
of the left hand chain stay.
3. Disconnect the motor power and motor con-
trols connectors.
4. Using a 19 mm spanner, loosen and remove
the hub axle nuts.
5. Loosen and remove the torque arm retention
bolt from the left hand side drop out.
6.
Remove the torque arm from the A2B by sli-
ding it off the axle.
7. Remove the rear wheel by sliding it out of the
frame while disengaging the chain from the free-
wheel.
Re-installing rear wheel
Reverse the removal instructions (7 -1).
• Re-install the torque arm. Failure to do so will
result in damage to the frame.
Ensure that the rear wheel is properly centred
in the frame before securely tightening the axle
nuts to 60 Nm.
Ensure that the brake disc is correctly inser-
ted in the brake calliper, and the wheel rotates
freely without interference from the brake shoes.
If you are unsure about this brake set-up and
adjustment procedure, please take your A2B to
your A2B dealer and ask for assistance in adjus-
ting the brakes. Improperly adjusted brakes may
cause reduced braking performance, leading to
an accident that could result in serious or fatal
injury and/or property damage. DO NOT ride your
A2B if you are not confident that the brakes are
working properly.
• Ensure correct replacement of the chain on the
front and rear chain rings.
• Install the cable clips for the motor cable to the
frame.
2
1