A.u.S Jolly PRO, Руководство по эксплуатации

Страница: 40 / 60

Jolly PRO – Operating Manual
40
d) To download the necessary files you need to upgrade your machine’s Firmware,
go to
https://aus.at/supportcenter/supportcenter.html
and click on the Support
tab.
In the event you have no internet access, you can request the
necessary files contacting the after-sales service at the following
telephone number: (
+43) (0)1 271 66 00.
e)
Unzip the file you have just downloaded (or received by the after-sales service) in
any folder on your PC.
f)
Copy all the Firmware files contained in the folder (without rename files and without
creating any folders inside) into the SD Card.
g)
Turn OFF the change machine Jolly PRO and make sure that the main switch of
the unit is in the OFF position.
h)
Insert again the SD Card into its slot onboard the machine’s CPU. Always observe
its orientation (the side with manufacturer's label facing up), and make sure to have
it properly pushed towards the bottom.
i)
Turn ON the machine.
j) Once you have turned on the machine, it
will display a screen very similar to the
one shown in Figure here on the right.
k)
Press the external blue button within 5
seconds to start upgrading. When the
upgrading is started, you will see a
screen very similar to the one shown in
Figure here on the right. In this screen
you can see the percentage of
completion
of the upgrading (its
progress is indicated by a percentage of
completion (%) from 0% to 100%.
l) At the end of upgrading, the change machine will show on the screen the
message “Complete! Rebooting”, as shown in the Figure here below.
m) Wait for the complete restart until, on the machine’s display, is shown the screen
you can see in the Figure at point n) below.