a-them AVM 70, Руководство по эксплуатации

Страница: 47 / 68

5.7 NETWORK / CONTROL
Network / Control
Network Status IP Address
Device Name XXX###
Wi-Fi MAC Address
Ethernet MAC Address
WPS
IP Status
Ethernet IP Settings
Wi-Fi IP Settings
Remote Control
Trigger 1 Selection
Trigger 2 Selection
Trigger 3 Selection
Trigger Delay None
Network Status
After the MRX/AVM connects to a local area network, the device’s IP address displays here.
Device Name
This option sets the name that the MRX/AVM broadcasts, and can be changed using up to 16 characters.
Wi-Fi / Ethernet MAC Address
This displays the two MAC addresses that belong to your MRX/AVM, one if you are using wireless control and another
for an Ethernet connection. MAC addresses are used for identifying your MRX/AVM on your network and cannot be
changed.
WPS
Use this method if your router has a WPS (Wi-Fi Protected Setup) button. After making the menu selection, press the
button on your router. Or, enable push-button mode by holding the Wireless button on the MRX/AVM’s rear panel for 5
seconds. The LED next to it should change its blink style. (tap again to cancel).
IP Con fi guration
Settings in this submenu should only be changed if your network administrator gives the direction or if using Direct
Connect to run ARC.
IP Con fi guration
Mode Auto (DHCP)
IP 192.168.000.001
Subnet Mask 255.255.255.000
Gateway 000.000.000.000