Page 1 0
! KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE !
07/2017
gas valve-hose connection (Figure 17)
inlet tube-bellows connection (Figure 18)
To perform a leak test:
1.
Make 2~3 oz. of leak solution by mixing one part liquid dishwashing detergent and three parts
water.
Noted: make sure control knob is
“
OFF
”.
2.
Apply several drops of solution where the cylinder attaches to regulator (see Figure 15), in-
spect the solution at the connection looking for bubbles. If NO bubbles appear, the connection
is secure. If bubbles appear, the connection has the leak, disconnect the regulator, reconnect,
perform another leak check. If you continue to see bubbles after several attempts, cylinder
valve is defective and should be returned to cylinder
’
s supplier.
3.
Apply several drops of solution where gas valve attaches to bellows (see Figure 16), where
gas valve attaches to hose (see Figure 17), and where inlet tube attaches to bellows (see Fig-
ure 18). If NO bubbles appear, the connections are secure. If bubbles appear, the connection
has the leak, disconnect, reconnect, perform another leak check. If you continue to see bub-
bles after several attempts, the part is defective and should replace the part.
LIGHTING INSTRUCTIONS
1.
Push in gas control knob slightly and turn to
“
OFF
”.
2.
Turn gas control knob the
“
ON/MIN
”.
3.
Push in gas control knob all the way and hold. Continue to press the ignition button for 15 sec-
onds.
4.
If the burner does not light in 15 seconds, release the knob and it will pop back out. Wait 5
minutes before attempting to light the burner again, repeat step 1 to 3.
1.
Push in gas control knob slightly and turn to
“
OFF
”.
WARNING:
For your safety, read and follow the Lighting Instructions in this manual and in the Rat-
ing Plate on the appliance. IMPROPER LIGHTING PROCEDURES COULD RESULT IN A FIRE
HAZARD OR EXPLOSION HAZARD OR PROPERTY DAMAGE, INJURY OR LOSS OF LIFE.
TO TURN OFF GAS
ignition button
gas control knob
Figure 19
