2
1
5
6
3
4
6
5
4
3
2
1
1
OVERVIEW
L
ong press: turn On & Off / Short press to cycle modes
Clean air exits here
Rechargeable battery
Communication connectors
Contaminated air enters here
Micro-USB socket
1. Function Button
2. Out Air-vent
3. Battery Cover
4. Pairing Link
5. In Air-vent
6. Charging Port
2
KEY FEATURES
4
QUICK START GUIDE
3
PACKAGE CONTENT
Preparation before use:
1. On the Battery Cover remove the battery
Plascide’s Micro-lightning
Anti-germ & VOCs technology
ACTIVE SANITIZATION
No germ-filled filters
No replacement cost
FILTER-LESS PROCESS
Sanitize within seconds
RAPID EFFECTIVENESS
Hours of battery operation
Wherever you go
CORDLESS PROTECTION
protector with the
pull-out tab
2. Charge the Air Halo
until battery is full
Please see:
6.4 Charging
1. Air Halo Sanitizer
2. Li-ion battery (Installed)
3. Micro-USB to USB cable
4. Manual
5. Warranty Card
1. Handle with care. Air Halo
can be damaged if dropped,
burned, punctured or
crushed.
2. Do not operate if damaged
and/or when the case is
broken to avoid potential
injury.
3. Charge with a Micro-USB
cable and a compatible USB
power adapter at 2.1A or
higher.
4. Do not charge or operate
with damaged Micro-USB
cables or damaged USB
power adapters.
5. Keep dry during operation
and storage. Do not operate
if wet and/or immersed in
any liquid to avoid potential
injuries and/or damages to
properties.
6. Do not allow infants and/
or young children to operate
unsupervised.
7. Do not insert any objects into
the in or out air-vents.
8. Do not operate without the
Out air-vent cover.
9. Do not block the In or Out
air-vents during operation.
10. Do not incinerate the Li-ion
battery. Recycle or dispose
separately from household
waste.
5
SAFETY PRECAUTIONS
6.2 Operational Modes
6.3 Mode Selection
6.4 Charging
MODE
TYPICAL USAGE
NORMAL
EvERydAy OptiMizEd pOwER
BOOSt
MAx cOvERAgE fOR dEMANdiNg SituAtiON
SiLENt
LOwER pOwER fOR quiEt ENviRONMENt
COnDITIOn
LED
BAttERy LOw
fLASH fOR ~60SEcS~
cHARgiNg
fLASH 6 tiMES
*
BAttERy fuLL
ON
*
low-light mode
: LEd wiLL tuRN Off witHiN A SEt tiME
1.
Long press horizontally to turn on/off
2.
Short press to cycle the different modes,
LED will flash when cycled
6.1 Function Button
6
OPERATION GUIDE
1. Charge with a Micro-USB cable
2. Connect the Micro-USB plug to the Air Halo
3. Connect the USB plug to a power adapter
Immediately after turning on, default mode is set
to
Normal
.
S H O RT
P R E S S
N O R M A L
B O O S T
L O N G
P R E S S
T U R N O N
S I L E N T
Pairing allows two Air Halos to function as
one when placed together or occupy the same
cupholder. Control both from any button and
charge from one USB cable.
Before Pairing,
Switch ON
both Air Halos
Press on either will control both units.
For more details see:
6.1 Function Button
Only one USB cable connected is required to
charge both units when using a generic power
adapter at 2.1A or higher.
For more details see:
6.4
Charging
1. Place the rear flat
face of the Air Halos
together
2. Align the Pairing Link
at the bottom
3. Both units will snap
together magnetically
4. Air Halos will begin
pairing automatically
5. Wait a few seconds
for pairing to finish
7.1 Air Halo Pairing
7.2 Mode Selection when Paired
7.3 Charge When Paired
7
AIR HALOS IN A PAIR
and do not separate the connection
6. Once synchronised, paired control will now
be enabled until you separate or switch off
