T-M32 / T-M32 ASME Service Manual
Ver. 1.03
69
CONFIDENTIAL
12-16. Manually adjusting the fan motor speed
While the FM+ dipswitch will automatically increase the fan speed by 7.5%, the fan motor speed on
the T-M32 can also be manually adjusted. In order to perform manual adjustments to the speed, a
remote controller is required.
Manually adjusting the fan motor speed of the T-M32 will change the amount of intake air
for combustion, which can cause excess CO emission from the exhaust chamber if the fan
motor speed is set incorrectly. Therefore, this procedure should never be performed
unless the Technical Services Department has given consent and authorization.
Adjusting maximum fan motor speed
1. While T-M32 is in operation, set dipswitch No.4 on T-M32 computer board to the “ON” position.
(Figure 1)
2. On the temperature remote controller, display mode #3 (fan motor speed) by entering the
“Diagnostics mode” (Refer to Section 12-1).
3. Press and hold down the “MAX” button on the computer board. While holding down the “MAX”
button, press either the “Increase” or “Decrease” button to increase or decrease the fan motor speed,
respectively (Figure 2). Refer to the remote controller display to verify that speed has been set to
desired value.
4. After fan speed has been set, set dipswitch No.4 back to the “OFF” position.
Adjusting minimum fan motor speed
1. While T-M32 is in operation, set dipswitch No.4 on T-M32 to the “ON” position. (Figure 1)
2. On the temperature remote controller, display mode #3 (fan motor speed) by entering the
“Diagnostics mode” (Refer to Section 12-1).
3. Press and hold down the “MIN” button on the computer board. While holding down the “MIN”
button, press either the “Increase” or “Decrease” button to increase or decrease the fan motor speed,
respectively (Figure 2). Refer to the remote controller display to verify that speed has been set to
desired value.
4. After fan speed has been set, set dipswitch No.4 back to the “OFF” position.
WARNING
Right bank of dipswitches
Figure 1
EEPROM
RE-CIR
LP
1
2
3
4
5
6
7
8
FM
N O
STORAGE
MAX button
MIN button
Increase button
Decrease button
Computer board
Figure 2
Right bank of dipswitches
