14
There are two types of modes depending on the actual water temperature inside the inner
tank of the water heater:
Modes
When the temperature of the water drops by 5°C from the set temperature due to usage of
water, the water heater again enters into the heating mode.
Figure 23
Heating mode
Standby mode
When the actual temperature of the water
is less than the set temperature, it enters
into Heating mode. The Heating LED
indicator glows as shown in (Fig. 23).
After the water heater reaches set temperature,
it will enter into the Standby mode due the
thermostat cut-off and Heating LED indicator
switch off as shown in (Fig. 24).
Figure 24
2kW
C
kWh
HEATING
SET
ON/OFF
ENERGY
METER
2kW
C
kWh
HEATING
SET
ON/OFF
ENERGY
METER
Figure 25
Energy Meter
This is used to display the energy consumed
by water heater for 5 seconds in kWh. The
new value will be added to the consumed
value and displays the total consumed value.
The Energy Meter value displayed is
cumulative. The LED display glows as shown
in (Fig. 25).
Reset function
Press and hold the ENERGY METER and
T
button simultaneously for 5 seconds, the
changed set temperature and the Energy
Meter value will be restored to factory
settings (set temperature value is made 70°C
and Energy Meter value resets to 0 kWh) and
water heater goes into initial power state.
While resetting, all LED indicators will glow
up for a while and then switch off as shown
in (Fig. 26).
2kW
C
kWh
HEATING
SET
ON/OFF
ENERGY
METER
2kW
C
kWh
HEATING
SET
ON/OFF
ENERGY
METER
ENERGY
METER
5 sec
Figure 26
Energy Meter values are indicative only.
To reset the Energy Meter (Refer “Reset Function”).
NOTICE
