A. J. ANTUNES & CO.
180 Kehoe Blvd., Carol Stream, Illinois 60188
INSTAllATION INSTrUCTIONS
SONIC fry STATION TImEr EST-3 (mfG. #9900651) & EST-3lS (mfG. #9900652)
General
If you experience any problems with these instructions,
contact the factory Technical Service Department at 630-
784-1000 or toll free in the U.S. at 877-392-7854.
Before you Begin
The Fry Station Timer (EST-3 and EST-3LS) is designed
to track the holding time for Tots, French Fries, and
Onion Rings. This helps stores provide consistently high
quality products.
The Fry Station Timer has three independent timer chan-
nels that track the proper holding. The Timer is solar
powered and mounts easily to the top of the Fry Station
with a supplied Mounting Bracket (Figure 2).
Three AA power backup batteries are included. The
EST-3LS also features an audible signal.
Installing the fry Station Timer
NOTE: Do NOT obstruct the solar cells at the front
and top of the Timer or the Timer may not function
properly.
NOTE. Do NOT locate the Timer in areas hotter than
120ºf (49ºC).
1. Take the Timer out of the box.
2. Attach the Timer to the screws on the canopy.
NOTE: In almost all cases, the canopy will have the
preexisting screws needed to hang the Timer. If your
canopy does not, then use the following steps to
mount the Timer.
1-877-392-7854 Fax: 630-784-1000
Page 1 of 2
P/N 1011049 Rev. A 02/10
Sonic
WArNING
Do NOT locate the timer in areas hotter than
120
º
f (49
º
C).
PARTS INCLUDED:
1 EST-3 Fry Station Timer (P/N 9900651)
OR
EST-3LS Fry Station Timer (P/N 9900652)
1 Instruction Sheet (P/N 1011049)
TOOLS NEEDED:
Phillips Screwdriver, Permanent Marker, Power Drill,
9/64” Drill Bit (hardened steel), Center Punch (automat-
ic or manual), Hammer (if using manual punch).
figure 1. fry Station Timer (EST-3lS shown)
figure 2. fry Station Timer (rear View)
a. Remove the Timer from the Mounting Bracket.
b. Place the Mounting Bracket against the canopy.
Level it, and use a permanent marker to mark two
spots on the canopy for drilling.
c. Place the tip of a center punch on each mark and
carefully strike to create an indentation for the drill
bit. Be careful not to dent the fry station canopy.
d. Place a 9/64” drill bit (hardened steel) into your
drill as far as possible so only the minimum bit is
exposed.
e. Drill the two holes. Be careful to only penetrate the
canopy and not damage any wiring that may be
present.
Mounting
Bracket
