DISPLAY CABINET HEATED
8
P/N 1010772 Rev. D 12/13
Figure 1. Display Components (DCH-100 Shown)
Unpacking
1. Remove unit and all packing materials from ship-
ping carton.
2. Open the large box. Remove all packing materi-
als and protective coverings from the unit and
parts.
NOTE: If any parts are missing, contact A.J
Antunes & Co. IMMEDIATELY at 1-877-392-7854 in
the U.S., or 630-784-1000 outside the U.S..
3. Wash all components in soap and water. Wipe
all surfaces of the unit with a hot damp cloth.
NOTE: Do not use a dripping wet cloth. Wring out
before use.
4. Install components in unit.
Equipment Setup
When placing the unit into service, pay attention to the
following guidelines:
• Make sure power to the unit is off and the unit is
at room temperature.
• Do not block or cover any openings on the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge of table or
counter.
• Place unit on a sturdy, level table or work sur-
face.
• Ensure that the line voltage corresponds to the
stated voltage on the unit specification label
located at the end of the power cord.
• Turn the Rocker Switch (power On/Off) to OFF.
Connect the unit to the power supply.
INSTALLATION
CAUTION
All electrical connections must be in accordance
with local electrical codes and any other appli-
cable codes.
WARNING
Be sure to follow all of the warnings and precau-
tions listed in the Important Safety Information
section of this manual.
Water Tray
(some models)
Heating Element
Shield
THIS UNIT IS DESIGNED TO
OPERATE
ON 120 VOLTS
ONLY
. APPLICATION WITH ANY
OTHER VOLTAGE SUPPLY
COMPLETELY
VOIDS ALL
WARRANTY
. PLEASE CHECK
YOUR LINE VOLTAGE BEFORE
INSERTING THIS PLUG INTO THE
RECEPTACLE.
WARNING
WARNING
120 VAC
ONLY
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS UNIT IS DESIGNED TO
OPERATE
ON 220-240 VOLTS
ONLY
. APPLICATION WITH ANY
OTHER VOLTAGE SUPPLY
COMPLETELY
VOIDS ALL
WARRANTY
. PLEASE CHECK
YOUR LINE VOLTAGE BEFORE
INSERTING THIS PLUG INTO THE
RECEPTACLE.
WARNING
WARNING
220-240
VAC ONLY
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
THIS APPLIANCE MUST BE
EARTHED (GROUNDED)
Crumb Tray
(some models)
Do NOT use with Water
Diffuser
(Only used with
Water Tray)
Heating
Element