8
11. Clean the outside of the spray gun and container with a cloth
soaked in solvent or water. Remove and clean the suction
tube. Use the supplied nozzle cleaner to unblock and residue
in the 3 small holes on the base of the suction tube end.
12. Unscrew the air cap nut. Remove air cap .Clean the air cap
and air cap nut with brush and solvent or water .
13. Use the supplied nozzle cleaner to unblock and clean any
paint residue in the small holes on the air cap.
Note:
Never clean the air cap or nozzle with sharp
metallic objects .
14. Remove the air filter cover (6) by inserting the end of a small
flathead screwdriver under the lip of the cover. Apply a small
amount of pressure until the lip of the cover comes away and
the full cover can be removed.
15. Remove the filter, wash with water, and allow to dry before
putting it back into place. Secure the air filter cover by
aligning the 4 clips on the underside of the air filter cover
into the 4 notches on the sprayer, and push them down into
position until they securely clip into place.
Trouble shooting
Problem
Cause
Remedy
No coating material is coming
out of the nozzle
The nozzle is blocked
The suction tube is blocked
The small hole in the suction tube is blocked
Air and Paint Volume Control Dial turned too far to the left (-)
Paint Volume Control Dial turned too far to the left (anti-clockwise)
The suction tube is loose
No pressure is built up in the paint pot
Clean
Clean
Clean
Turn to the right (+)
Turn to the left (anti-clockwise)
Turn to the right(clockwise)
Tighten paint pot
The coating material drips
from the nozzle
The nozzle is loose
The nozzle is worn
Build up of coating material in the air cap and nozzle
Tighten
Change
Clean
Spray too coarse
Coating material has a too high viscosity
Too much material
Paint Volume Control Dial turned too far to the right(+)
Air and Paint Volume Control Dial turned too far
to the left (anti-clockwise)
Nozzle dirty
Air filter very dirty
Not enough pressure built up in container
Dilute
Turn Paint Volume Control Dial to the left (-)
Turn to the left (-)
Turn Paint Volume Control Dial to
the right(clockwise)
Clean
Change
Tighten paint pot
The spray jet pulses
Coating material in paint pot is running out
The small hole in the suction tube is blocked
Air filter very dirty
Refill
Clean
Clean / Change
Run in the coating material
Too much coating material applied
Turn the Paint Volume Control Dial to the left (-)
Too much coating material mist
(overspray)
The distance to the object to be sprayed is too large
Too much coating material applied
Reduce spraying distance
Turn Paint Volume Control Dial to the left (-)
