909 KSBL26CCG, Инструкция по эксплуатации

Страница: 9 / 15

9
Assembly
IMPORTANT. Blower tube installation affects both
blower balance and performance. Both tube and nozzle
must be screwed together.
WARNING. Danger from rotating impeller!
Stop the engine before installing or removing the blower
tubes. Never perform any maintenance or assembly
procedures on this machine while the engine is running.
1. Place the blower upright on the ground or on a sturdy
work surface.
2. Push the nozzle tube (5) over the straight tube (4), lining
up the locking pins.
3. Rotate the nozzle tube clockwise locking it into place.
4. Lock the tubes together using the 2 screws provided.
5. Align and then push the
assembled blower tube over
the discharge port and rotate
until locks in place and the
screw hole can be seen.
6. Screw the tubes together
using the screws provided.
Mixing the fuel
ENGINE FUEL: MIX AT 40:1
WARNING
. When mixing fuel it is recommended to wear
eye protection, and to mix fuel in a well ventilated location.
Note. This is 25mls of 2 stroke oil with 1 litre of unleaded petrol
OR 125mls of 2 stroke oil with 5 litres of unleaded petrol.
IMPORTANT. Use good quality air cooled 2-stroke
engine oil.
This product is powered by a 2-stroke engine and requires
the pre-mixing of fuel with 2-stroke oil.
1. Use fresh unleaded petrol and a good grade of 2 stroke
oil for air cooled 2 stroke engines.
2. Mix the petrol and oil in an approved container.
Never mix fuel directly in the blower fuel tank.
A fuel mixing container is provided with this blower.
Directions. Place the plastic mixing bottle on a level
surface. Fill with unleaded fuel in the container to the top
500 marker in the column GAS.
Then with 2 stroke oil, fill to the top line maker in the 40:1
column. Replace the cap on the mixing bottle and shake the
container to mix the fuel and oil.
The fuel is now correctly mixed at 40:1 and is ready to be
poured into the petrol tank of the blower.
NOTE, this container provided is NOT a fuel storage container.
WARNING . Never use any type of pre-mixed fuel/oil direct
from fuel stations. This may include special blends intended
for use in mopeds, motorcycles, etc.
3. Mix the fuel thoroughly and also each time before fuelling.
4. Always pre-mix in small quantities. Never mix quantities
larger than what will be used in a 30 day period.
Note. Do not store petrol in plastic containers.
Keep fuel out of the reach of children.
40:1