909 DYM-1773, Инструкция по эксплуатации

Страница: 10 / 16

10
6.3 Operation procedures
During operation, tightly hold the brake handle with both
hands.
Note:
During operation, when the brake handle is released,
the engine will stop and thus stopping the lawnmower from
operating.
6.4 To stop engine
CAUTION: The blade continues to rotate for a few seconds
after the engine is shut off.
1. Release the brake control handle to stop the engine and
blade.
2. Disconnect and ground the spark plug wire as instructed
in the separate engine manual to prevent accidental
starting while equipment is unattended.
6.5 For the best results when mowing
Clear lawn of debris. Be sure that the lawn is clear of
stones, sticks, wire or other foreign objects which could be
accidentally thrown out by the mower in any direction and
cause serious personal injury to the operator and others
as well as damage to property and surrounding objects.
Do not cut wet grass. For effective mowing do not cut wet
grass because it tends to stick to the underside of the deck
preventing proper mowing of the grass clippings. Cut no
more than 1/3 the length of the grass. The recommended
cut for mowing is 1/3 the length of the grass. Ground speed
will need to be adjusted so the clippings can be dispersed
evenly into the lawn. For especially heavy cutting in thick
grass it may be necessary to use one of the slowest speeds
in order to get a clean well mowed cut. When mowing long
grass you may have to cut the lawn in two passes, lowering
the blade another 1/3 of the length for the second cut and
perhaps cutting in a different pattern than was used the first
time. Overlapping the cut a little on each pass will also help
to clean up any stray clippings left on the lawn. The mower
should always be operated at full throttle to get the best cut
and allow it to do the most effective job of mowing.
Clean underside of deck. Be certain to clean the underside
of the cutting deck after each use to avoid a build-up of
grass, which would prevent proper mulching. Mowing
leaves. The mowing of leaves can also be beneficial to your
lawn. When mowing leaves make sure they are dry and
are not laying too thick on the lawn. Do not wait for all the
leaves to be off the trees before you mow.
WARNING: if you strike a foreign object, stop the engine.
Remove wire from spark plug, thoroughly inspect the mower
for any damage and repair the damage before restarting
and operating the mower. Extensive vibration of the mower
during operation is an indication of damage. The unit should
be promptly inspected and repaired.
6.6 Grass catcher
There is a window on the
rear cover. You can see the
condition of grass catcher
through the window. If the
catcher is full of grass; you
will empty and clean the
bag, make sure it is clean
and ensure its meshwork is
ventilated. (Fig. 10)
6.7 Deck
The underside of the mower deck should be cleaned after
each use to prevent a buildup of grass clippings, leaves, dirt
or other matter. If this debris is allowed to accumulate, it will
invite rust and corrosion, and may prevent proper mulching.
The deck may be cleaned by tilting the mower and scraping
clean with a suitable tool (make certain the spark plug wire
is disconnected).
Fig. 10