909 255SB, Инструкция по эксплуатации

Страница: 12 / 20

12
Dust bag
The dust bag (14) fits over
the dust extraction port (26).
For more efficient operation,
empty the dust bag when it
is no more than half full. This
allows better air flow through
the bag (Fig. L).
Attaching
the side bars
The side support bars (34)
help to support the material
when working with long
workpieces. There are two
location holes (35) for a
support bar on either side of
the table. Loosen the lock
screws (36) with the 6mm
hex key. Ensure the side bars
are fully inserted before using
them to support the workpiece
(Fig. M).
The side support bar locking
screws (36) must be tightened
to secure the support bars in
position (Fig. N).
Trench depth
adjustment
In its normal position, the
trenching stop (30) permits
the saw blade to cut right
through a workpiece. When
the saw arm is lifted, the
trenching stop can be moved
to the left so that the trenching
depth adjustment screw (29)
contacts the stop as the saw
arm is lowered. (Fig. O).
This restricts the cut to a “trench” in the workpiece. The
depth of the trench can be adjusted with the trenching depth
adjustment screw (29) (Fig. P) and locked in position with
the trenching depth lock nut (31) (Fig. Q).
Turning on and off
1. Pull in switch trigger to start
the unit (Fig. R).
2. To turn the saw off release
the on/off trigger switch (23).
Turning on the
laser line generator
The laser line generator emits
a single beam of pure red
light to guide you as
you cut. It improves operator
cutting vision, enables faster
set-up, increases accuracy
and improves safety. To turn
on the laser lines press the
laser light on/off switch (2)
(Fig. S). To turn off the laser
press the laser light on/off
switch (2) one more time.
Q
L
M
N
O
P
R
S