909 10301, Инструкция по эксплуатации

Страница: 5 / 12

5
•
When an extension cord is used:
– The marked rating of the detachable power supply
cord or extension cord should be at least as great as
the electrical rating of this appliance.
– The cord should be arranged so that it will not drape
over the countertop or tabletop where it can be
tripped over, snagged, or pulled on unintentionally
(especially by children).
– The extension cord should be kept dry and off the
ground.
– Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one
heavy enough to carry the current your product will
draw. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating.
The following table shows the correct size to use
depending on cord length and nameplate ampere
rating. If in doubt, use the next heavier gage. The
smaller the gage number, the heavier the cord.
– When tool is used outdoors, use only extension cords
intended for use outdoors and so marked.
WARNING: FIRE HAZARD: Never contact combustible
material to the lens and never tape or tie the switch in
the on position.
Additional safety instructions for the charger
• Before using the charger, read all the instructions and
cautionary markings on the charger and torch.
• Only charge your torch indoors as the charger is
designed for indoor use only.
• WARNING. Do not allow any liquid to come into contact
with the charger. There is a danger of electric shock.
• The charger is not intended for any use other than
charging the exact type of rechargeable torch as supplied
with the charger. Any other use may result in the risk of
fire, electric shock or electrocution.
• The charger and torch are specifically designed to work
together. Do not attempt to charge the torch with any
other charger than the one supplied.
• Do not place any object on top of the charger as it could
cause overheating. Do not place the charger near any
heat source.
• Do not pull on the lead of the charger to disconnect it
from the power source.
• Make sure that the charger cable is positioned where
it will not be stepped on, tripped over or otherwise
subjected to damage or stress.
• Do not use an extension cord unless it is absolutely
necessary. The use of an improper extension cord could
cause the risk of fire, electric shock or electrocution.
• Do not use the charger if it has been subjected to a
heavy knock, dropped or otherwise damaged in any way.
Take the charger to a power tool repair centre for a check
or repair.
• Do not disassemble the charger. Take it to power tool
repair centre when service or repair is required. Incorrect
re-assembly may result in the risk of fire, electric shock or
electrocution.
• The charger is designed for use from a standard
household electrical supply (230–240 volts). Do not
attempt to connect the charger to a supply with a
different supply.
CAUTION: To reduce the risk of injury or property
damage:
• All halogen lights give off heat:
– Do not touch lens while operating.
– Keep combustibles away from spotlight lens. Extreme
heat can cause fires.
– Never place the light face-down on any surface
when lit.
• Never look directly into the light or shine the light into
another person’s eyes.