80% Arms AR-15 Easy Jig, Руководство пользователя

Страница: 15 / 20

STEP 15:
To mill the trigger slot, remove the Trigger Pocket Template #05 and
set the Rear Shelf Pocket Template #06 on the jig, with the raised
lip facing up. Secure the Router Base Support Plate #07 on top of the
template using only the 2 short Trigger Milling Bolts #10. Only use 2 bolts
to attach the template and base plate. Insert the screws into the 2 holes on
the base plate closest to the buffer tube, using the 2 screw holes on the jig
side plates furthest from the buffer tube. The smaller trigger slot should be
located closest to the buffer tube. The larger slot over the magazine well
is not used. Adjust the router depth setting so the end mill is slightly
inside the drilled out trigger slot pilot hole. With the end mill centered in
the hole, turn on the router while keeping a firm grip on the router. Mill back
and forth in a clockwise motion. Turn off the router and increase the depth
by 1/6 to 1/4 notch and repeat the process. Continue until the trigger slot is
fully milled out.
TIP:
Only if using a full sized router with a large base, insert the Template Spacer
#04 between the Pocket Template #06 and the jig wall, and use 2 of the longer
1.75” Template Bolts #9 instead of the short Trigger Milling Bolts. This will elevate
the Router Support plate to allow a larger router base to clear the buffer tube
.
-
14 -
X