80/20 XDIY1707, Быстрый старт

Страница: 4 / 6

ASSEMBLY INSTRUCTIONS
Start by building the base of the
cabinet upside down. Connect
profile E (2) and profile F (2) using
anchor fasteners (8), profile A (2)
and profile D (2) as vertical uprights.
A
E
B
C
D
F
Panel J
Panel H
Panel I
Detent Hinge
Flush Handle
Caster
Slide panel I (2) into open T-slots on
long side of the build.
Preload half of detent hinge (4)
onto panel J (2) using 10-32 x .625”
BHSCS with hex nut and washer
(8). Preload other half of hinge with
10-32 x .500” BHSCS and T-nut (8).
Install flush handle (2) into open slot
of panel J.
Slide hinges into outside T-slot of
vertical uprights on short side of
build. Center door on profile and
tighten down.
Connect profile C (1) on panel I on long
side of build using anchor fastener (2).
With profile B (2) on each short end, install
panel H (1) into profile C. Close off the
build with another profile C (1) on the other
long side of panel H. Finish tightening the
profiles down using anchor fastener (6).
Install casters (4) into vertical upright ends
by threading the stem in with a box end
wrench.
1
2
3