4PRO 4PRO8016, Оригинальное руководство пользователя

Страница: 13 / 27

WARNING!
Always disconnect the tool from the compressed air before loading. When
loading the tool always point the tool away from yourself and others. Make sure that you are not
holding the tool with trigger depressed while loading the tool.
1. Disconnect the tool from the air supply .Grasp the nailer firmly with one hand.Press the latch with
your thumb and pull the magazine back. Insert a strip of fasteners into magazine Keeping it point down.
2. Release the latch and pusher, slid the pusher against the nails until it contacts the nails and lock into
place. The tool is now ready for use.
3. Connect the tool to the air supply. Make sure the air pressure is in the correct range denoted in the
Technical Data.
4. Then test the driving depth in a sample piece of wood before using. If the fasteners are being driven
too far or not far enough, adjust the regulator to provide less air pressure or more air pressure.
WARNING!
Disconnect the tool from the air compressor before adjusting, clearing jams,
servicing & maintenance, relocating and during non operation.
·Regular lubrication, if your tool without using the in-liner automatic oilier, place 2 or 6 drops of
pneumatic tool oil recommended by Ottensten Polska Sp. Zo.o. into the air inlet before each work day or
after 2 hours of continuous use depending on the characteristic of workpiece or type of fasteners.
·Air-operated tools must be inspected periodically, and worn or broken parts must be replaced to keep
the tool operating safely and efficiently. Check and change all worn or damaged O-rings, seals, etc.
Tight all the screws and caps in case personal injury.
·Make regular inspection for free movement of trigger, Spring and safety mechanism to assure safe
system is complete and functional: no loose and missing parts, no building or sticking parts.
·Keep magazine and nose of tool clean and free of any dirt lint or abrasive particles.
·When temperatures are below freezing, tools should be kept warm by any convenient, safe method.
► FASTENERS DRIVING TOOLS OPERATED BY COMPRESSED AIR
SHOULD BE ONLY OPERATED AT THE LOWEST PRESSURE REQUIRED
FOR THE WORK PROCESS AT HAND IN ORDER TO PREVENT
UNNECESSARILY HIGH NOISE LEVELS, INCREASED WEAR AND
RESULTING FAILURES.
WARNING!
Never operate tool unless nose is in contact with workpiece. Do not operate
tool without fasteners or damage to tool may result.
Never fire fasteners into air because fasteners may injury operator or others and damage to tool
may result.
5. The tool is equipped with a push-button switch* that can change the operating mode from sequent fire
to single fire. When the red stop button is pushed in from the fasteners loading side, the tool will fire one
fastener only. To fire the next fastener, the trigger must be released.
* this refers to tools with contact actuation (equipped with safety yoke)
LOADING FASTENER AND OPERATION
MAINTENANCE
13